No changes between revisions
| /contrib/toolchain/avra/examples/testcode_avra-1_2_3.asm |
|---|
| 0,0 → 1,19 |
|---|
| .device ATmega8 |
| + .db 1,2 |
|---|
| + .message "The previous line is ignored with avra-1.2.2 because .org 0 is terminated with CR only. " |
|---|
| + .message "This is line 5 but avra-1.2.2 shows line 4" |
|---|
| + .db "X%MINUTE%YEAR%" ; Take a look at this percent chars too : % % % % |
|---|
| + .db "%YEAR%HELLO%" ; Strange replacement, if one percent char is missing |
|---|
| + .db "%HOUR%:%MINUTE%%" |
|---|
| + .db "øC" ; Look at the special char. (Error in listing only. HEX-file was ok) |
|---|
| + ; Additional warning : Don't use linux editors with UTF charset ! A single special char |
|---|
| + ; (Code > 127 in codepage 850 e.g. german umlauts) could be an unvisible TWO bytes sequence |
|---|
| + ; in UTF coding. To be on the save side never use chars with code > 127. |
|---|
| + ; It's better to replace them by the code e.g. .db "M",129,"nchen" (german town 'Munich') |
|---|
| + ldi R16, ';' ; This is wrong with avra-1.2.2. |
|---|
| + ldi R16, 0x3b ; Should generate same code like above |
|---|
| + |
|---|
| +; TODO : |
|---|
| +; ldi R16,high (11111) ; "high(" is OK, "high (" isn't. Same with other functions... |
|---|
| + |
|---|