| 0,0 → 1,200 |
|---|
| |
| |
| // |
| // Device and Vendor IDs - Needed like this for OSS only |
| // |
| #define CYRIX_VENDOR_ID 0x1078 |
| #define NATIONAL_VENDOR_ID 0x100B |
| |
| // |
| // Audio Device IDs |
| // |
| #define CX5530_DEV_ID 0x0103 |
| #define SC1200_DEV_ID 0x0503 |
| #define CS5535_DEV_ID 0x002E |
| |
| // |
| // Function 3 of 5530 PCI dev is Audio (ISA idx). |
| // |
| #define PCI_FUNC3_AUDIO 0x300 |
| #define PCI_AUDIO_CMD_REG 0x04 |
| |
| typedef unsigned char AUDIO_STATE; |
| |
| #define AUDIO_STATE_IGNORE 0 |
| #define AUDIO_STATE_IN_RECORDING 0x01 |
| #define AUDIO_STATE_IN_OVERFLOW 0x02 |
| #define AUDIO_STATE_IN_STOPPED 0x03 |
| #define AUDIO_STATE_IN_MASK 0x0F |
| #define AUDIO_STATE_OUT_PLAYING 0x10 |
| #define AUDIO_STATE_OUT_UNDERFLOW 0x20 |
| #define AUDIO_STATE_OUT_STOPPED 0x30 |
| #define AUDIO_STATE_OUT_MASK 0xF0 |
| |
| #define RECORD_RUNNING 0x01 |
| #define RECORD_OVERFLOW 0x02 |
| #define RECORD_STOPPED 0x03 |
| |
| #define PLAYBACK_RUNNING 0x10 |
| #define PLAYBACK_UNDERFLOW 0x20 |
| #define PLAYBACK_STOPPED 0x30 |
| |
| // |
| // The CODEC commands are actually 16-bit words, into which is inserted |
| // the codec "target" register, identified by a byte. The 5530 Codec |
| // controller writes a command unsigned short of 32-bits, that includes the codec |
| // command unsigned short. |
| // |
| #define CODEC_COMMAND_MASK 0xFF00FFFF |
| |
| // |
| // The Interaction with the CODEC is a bit cumbersome |
| // because of the serial interface. |
| // |
| #define CODEC_STATUS_REG 0x08 // In Audio mem-map. |
| #define CODEC_CMD_REG 0x0c // In audio mem-map. |
| #define CODEC_CMD_VALID 0x00010000 |
| #define CODEC_STATUS_VALID 0x00020000 |
| #define CODEC_STATUS_NEW 0x00010000 |
| #define BIT_CODEC_READY 0x00800000 |
| |
| // |
| // Registers for the 5535 |
| // |
| #define CODEC_STATUS_REG_5535 0x08 |
| #define CODEC_CONTROL_REG_5535 0x0c |
| |
| // |
| // 5535 Bits |
| // |
| #define BIT_5535_CODEC_COMMAND_NEW 0x00010000 |
| #define BIT_5535_CODEC_STATUS_NEW 0x00020000 |
| #define BIT_5535_ACLINK_SHUTDOWN 0x00040000 |
| #define BIT_5535_ACLINK_WARM_RESET 0x00020000 |
| #define BIT_5535_CODEC_READY_PRIM 0x00800000 |
| |
| // |
| // Codec register indexes. Note these are all shifted left by 16 bits. |
| // |
| #define RESET 0x00 |
| #define MASTER_VOLUME 0x02 |
| #define LINE_LEV_OUT_VOL 0x04 |
| #define MASTER_VOLUME_MONO 0x06 |
| #define MASTER_TONE_RL 0x08 |
| #define PC_BEEP_VOLUME 0x0a |
| #define PHONE_VOLUME 0x0c |
| #define MIC_VOLUME 0x0e |
| #define LINE_IN_VOLUME 0x10 |
| #define CD_VOLUME 0x12 |
| #define VIDEO_VOLUME 0x14 |
| #define TV_VOLUME 0x16 |
| #define PCM_OUT_VOL 0x18 |
| #define RECORD_SELECT 0x1a |
| #define RECORD_GAIN 0x1c |
| #define RECORD_MIC_GAIN 0x1e |
| #define GENERAL_PURPOSE 0x20 |
| #define CONTROL_3D 0x22 |
| #define MODEM_RATE 0x24 |
| #define POWERDOWN_CTRL_STAT 0x26 |
| #define EXTENDED_AUDIO_ID 0x28 |
| #define EXT_AUDIO_CTRL_STAT 0x2A |
| #define PCM_FRONT_DAC_RATE 0x2C |
| #define PCM_LR_ADC_RATE 0x32 |
| #define VENDOR_ID1 0x7c |
| #define VENDOR_ID2 0x7e |
| |
| #define MUTE_MASK 0x8000 |
| #define HEADHONE_AVAIL 0x0010 |
| #define LINE_LEV_RESET_VOL 0x0000 // the reset without the mask |
| |
| #ifdef AC97_2DOT1_6BIT_COMPLIANT |
| # define MASTER_ATTEN_CTL_BITS 6 |
| #else |
| # define MASTER_ATTEN_CTL_BITS 5 |
| #endif |
| |
| #define MASTER_VOLUME_MAX ( ( 1 << MASTER_ATTEN_CTL_BITS ) - 1 ) |
| #define LINE_LEV_OUT_MAX ( ( 1 << MASTER_ATTEN_CTL_BITS ) - 1 ) |
| |
| // |
| // AD1819A registers |
| // |
| #define AD1819A_SER_CONF 0x74 |
| #define AD1819A_SER_CONF_DRQEN 0x08 |
| #define AD1819A_MISC 0x76 |
| #define AD1819A_PCM_SR0 0x78 |
| #define AD1819A_PCM_SR1 0x7A |
| #define AD1819A_VENDORID1 0x7C |
| #define AD1819A_VENDORID2 0x7E |
| |
| // |
| // Power Management bits |
| // |
| #define GEODEAUDIO_PWR_PR0 0x0100 // PCM in ADC's & input Mux Powerdown |
| #define GEODEAUDIO_PWR_PR1 0x0200 // PCM out DACs Powerdown |
| #define GEODEAUDIO_PWR_PR2 0x0400 // Analog Mixer powerdown (Vref still on) |
| #define GEODEAUDIO_PWR_PR3 0x0800 // Analog Mxer powerdown (Vref off) |
| #define GEODEAUDIO_PWR_PR4 0x1000 // Digital interface (AC-link) powerdown (external clk off) |
| #define GEODEAUDIO_PWR_PR5 0x2000 // Internal Clk disable |
| #define GEODEAUDIO_PWR_PR6 0x4000 // HP amp powerdown |
| #define GEODEAUDIO_PWR_PR7 0x8000 // External Amplifier Power Down |
| |
| #define GEODEAUDIO_PWR_D0 0x0000 |
| #define GEODEAUDIO_PWR_D1 GEODEAUDIO_PWR_EXTOFF |
| #define GEODEAUDIO_PWR_D2 GEODEAUDIO_PWR_PR0|GEODEAUDIO_PWR_PR1|GEODEAUDIO_PWR_PR2|GEODEAUDIO_PWR_PR6|GEODEAUDIO_PWR_PR7 |
| #define GEODEAUDIO_PWR_D3 GEODEAUDIO_PWR_PR0|GEODEAUDIO_PWR_PR1|GEODEAUDIO_PWR_PR2|GEODEAUDIO_PWR_PR6|GEODEAUDIO_PWR_PR7 |
| #define GEODEAUDIO_PWR_D4 GEODEAUDIO_PWR_PR0|GEODEAUDIO_PWR_PR1|GEODEAUDIO_PWR_PR2|GEODEAUDIO_PWR_PR3|GEODEAUDIO_PWR_PR4|GEODEAUDIO_PWR_PR5|GEODEAUDIO_PWR_PR6|GEODEAUDIO_PWR_PR7 |
| #define GEODEAUDIO_PWR_ANLOFF GEODEAUDIO_PWR_PR2|GEODEAUDIO_PWR_PR3 // Analog section OFF |
| #define GEODEAUDIO_PWR_EXTOFF GEODEAUDIO_PWR_PR6|GEODEAUDIO_PWR_PR7 // HP amp and External Amplifier OFF |
| #define GEODEAUDIO_PWR_D1_HAWK GEODEAUDIO_PWR_PR0|GEODEAUDIO_PWR_PR1|GEODEAUDIO_PWR_PR2|GEODEAUDIO_PWR_PR3|GEODEAUDIO_PWR_PR4 |
| #define GEODEAUDIO_PWR_DIGOFF GEODEAUDIO_PWR_PR0|GEODEAUDIO_PWR_PR1 // Digital section OFF |
| |
| #define GEODEAUDIO_PWRUP_STEP1 0x0F00 // Clear EAPD,PR6 and AC-link to power up external and HP amp and Digital interface |
| #define GEODEAUDIO_PWRUP_STEP2 0x0700 // Clear PR3 to power up Analog (Vref off) |
| #define GEODEAUDIO_PWRUP_STEP3 0x0300 // Clear PR2 to power up Analog (Vref on) |
| #define GEODEAUDIO_PWRUP_STEP4 0x0100 // Clear PR1 to power up DAC |
| #define GEODEAUDIO_PWRUP_STEP5 0x0000 // Clear PR0 to power up ADC |
| |
| #define GEODEAUDIO_CODEC_POWER_ADC 0x0001 |
| #define GEODEAUDIO_CODEC_POWER_DAC 0x0002 |
| #define GEODEAUDIO_CODEC_POWER_ANL 0x0004 |
| #define GEODEAUDIO_CODEC_POWER_REF 0x0008 |
| |
| // |
| // Device Power States |
| // |
| typedef enum _GEODEAUDIO_POWER_STATE |
| { |
| GEODEAUDIO_D0 = 0, // Full On: full power, full functionality |
| GEODEAUDIO_D1, // Low Power On: fully functional at low power/performance |
| GEODEAUDIO_D2, // Standby: partially powered with automatic wake |
| GEODEAUDIO_D3, // Sleep: partially powered with device initiated wake |
| GEODEAUDIO_D4, // Off: unpowered |
| } GEODEAUDIO_POWER_STATE, *PGEODEAUDIO_POWER_STATE; |
| |
| // PRD table flags |
| #define PRD_JMP_BIT 0x20000000 |
| #define PRD_EOP_BIT 0x40000000 |
| #define PRD_EOT_BIT 0x80000000 |
| |
| typedef struct tagPRDEntry |
| { |
| unsigned long ulPhysAddr; |
| unsigned long SizeFlags; |
| } PRD_ENTRY, *PPRD_ENTRY; |
| |
| |
| // |
| // Command register bits |
| // |
| #define PCI_READS 0x00 |
| #define PCI_WRITES 0x08 |
| |
| #define ENABLE_BUSMASTER 0x01 |
| #define PAUSE_BUSMASTER 0x03 |
| #define STOP_BUSMASTER 0x00 |
| |
| #define CHANNEL0_PLAYBACK 0 |
| #define CHANNEL1_RECORD 1 |
| #define MAX_CHANNELS 2 |
| |