| 29,11 → 29,6 |
|---|
| USB_OTHER_SPEED_CONFIG_DESCR = 7 |
| USB_INTERFACE_POWER_DESCR = 8 |
| |
| ; Possible speeds of USB devices |
| USB_SPEED_FS = 0 ; full-speed |
| USB_SPEED_LS = 1 ; low-speed |
| USB_SPEED_HS = 2 ; high-speed |
| |
| ; Compile-time setting. If set, the code will dump all descriptors as they are |
| ; read to the debug board. |
| USB_DUMP_DESCRIPTORS = 1 |
| 370,7 → 365,7 |
|---|
| ; so setting the address could take some time until the cache is evicted. |
| ; Thus, the call is asynchronous; meet us in usb_after_set_address when it will |
| ; be safe to continue. |
| dbgstr 'address set in device' |
| ; dbgstr 'address set in device' |
| call [eax+usb_hardware_func.SetDeviceAddress] |
| ; 2b. If the port is in non-root hub, clear 'reset in progress' flag. |
| ; In any case, proceed to 4. |
| 409,7 → 404,7 |
|---|
| ; is cleared after request from usb_set_address_callback. |
| ; in: ebx -> usb_pipe |
| proc usb_after_set_address |
| dbgstr 'address set for controller' |
| ; dbgstr 'address set for controller' |
| ; Issue control transfer GET_DESCRIPTOR(DEVICE_DESCR) for first 8 bytes. |
| ; Remember, we still do not know the actual packet size; |
| ; 8-bytes-request is safe. |